A novel 19-level inverter topology based on a single direct current source and reduced component count
Abstract
Conventional multilevel inverters (MLI) provide low harmonic distortion but often require many switches, passive components, and voltage sensors, increasing cost, size, and control complexity. This paper proposes a compact 19-level modified split-packed U-cell (MSPUC) inverter powered through one independent direct current (DC) supply source. The proposed configuration employs a reduced number of switches and only three capacitors. Its key contribution is the natural self-balancing of capacitor voltages under sensorless open-loop pulse width modulation (PWM) operation, eliminating the need for additional voltage sensors or auxiliary balancing circuits. In addition, the topology achieves a total standing voltage per unit (TSVpu) of 4.22 and a cost function (CF) of 1.70, indicating reduced voltage stress and improved structural efficiency. MATLAB/Simulink simulations are performed under steady-state conditions, load variations, nonlinear loading, switching-frequency variation, and sudden DC-source disturbances. The obtained results confirm stable capacitor voltage regulation, fast dynamic response, and high-quality output waveforms. Under the nominal condition of R=20 ohm and L=20 mH, the load current total harmonic distortion (THD) is limited to 0.96% without using any external filter. Therefore, the proposed MSPUC inverter provides a compact, cost-effective, and low-complexity solution for efficient power electronic conversion systems.
Keywords
Multilevel inverters; Packed U-cell; Sinusoidal pulse width modulation; Total blocking voltage; Total harmonic distortion; Total standing voltage
Full Text:
PDFDOI: https://doi.org/10.11591/eei.v15i6.11776
Refbacks
- There are currently no refbacks.

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Bulletin of Electrical Engineering and Informatics (BEEI)
ISSN: 2089-3191
,
e-ISSN: 2302-9285
This journal is published by the
Institute of Advanced Engineering and Science (IAES)
.